No heat
A blown thermal fuse, failed heater or thermostat.
Vented, condenser and heat pump dryers repaired at home, including washer-dryers and stacked sets.
Tell us what it’s doing and we’ll usually know the likely cause before we arrive.
A blown thermal fuse, failed heater or thermostat.
A snapped drum belt or a worn motor or idler pulley.
Blocked lint filter, vent hose or condenser, or a weak heater.
Worn drum rollers, bearings or felt seals.
Overheating from a blocked vent, or a sensor fault.
Condenser dryers with a blocked pump or full water tank line.
Clean the lint filter after every load and check the vent hose isn’t crushed behind the dryer.
Book below, call or WhatsApp a photo of the fault.
A technician who knows your appliance, with common parts in the van.
The fault and the full price, before any work starts.
Tested with you and covered by our warranty.
Still not sure? Call 0725 570 499 or send a photo of the fault on WhatsApp.
Most often a blown thermal fuse or failed heater. A blocked vent is usually what caused the fuse to blow, so we clear that too.
The drum belt has usually snapped. It is a common, quick repair.
Yes, both the washing and drying sides.
Three quick steps. We confirm your time on WhatsApp.
Free diagnosis, genuine parts and a warranty on every repair.