No spark
A failed ignition module, wet or cracked electrode, or a stuck switch.
Built-in and table-top gas hobs repaired safely at your home. Ignition, burners, valves and safety devices, tested before we leave.
Tell us what it’s doing and we’ll usually know the likely cause before we arrive.
A failed ignition module, wet or cracked electrode, or a stuck switch.
The flame failure device (thermocouple) is worn or dirty.
Blocked burner holes or injector, or the wrong regulator.
Water or grease on the ignition switch, or a faulty module.
Worn gas valves or broken knob spindles.
A leaking pipe, hose or valve. Turn off the gas and call us.
Safety first: if you smell gas, turn off the cylinder, open the windows and don’t touch any switches. For ignition problems, dry the burner heads fully after cleaning. Wet burners are the most common cause.
Book below, call or WhatsApp a photo of the fault.
A technician who knows your appliance, with common parts in the van.
The fault and the full price, before any work starts.
Tested with you and covered by our warranty.
Still not sure? Call 0725 570 499 or send a photo of the fault on WhatsApp.
Usually a wet or dirty electrode, a blocked burner, or a weak ignition module. We clean, test and replace what’s needed.
The flame failure device (thermocouple) is worn or not sitting in the flame. It is a safety part and we replace it with the right type.
Yes. We fit and leak-test new hobs, hoses and regulators.
Three quick steps. We confirm your time on WhatsApp.
Free diagnosis, genuine parts and a warranty on every repair.